POLYMER BASED TILE ADHESIVE
brix tilo 916 is blend of Portland cements, polymers and fillers.
BS 5980:1980, Draft CEN:prEN 12004-1997
Bulk Density : 1650 kg/m3
Pot Life of paste : 45 min at 35oC
Form : Free flowing powder
Colour : Grey
Ensure the surface to be tiled is clean. Mix the powder and water in 3:1 ratio. Thoroughly mix to form a
creamy paste, leave it for 10 minutes for maturing and apply this paste to the surface to be tiled and press
the tile in position firmly. An adhesion thickness of 3mm is enough to create a good bond. Allow tiles to
set for 24 hours before grouting.
No soaking of tiles required minimising breakages during soaking and extra labour.
No wetting of surface to be tiled.
No curing is required.
Surface to be tiled does not need hacking or mechanical key.
Waterproofs the tiled surface.
Excellent adhesion to smooth surface such as existing tiles, mosaic surface etc.
All equipment and tools must be cleaned immediately after use with water or cleaning solvents as the
case may be. Similar procedure should be adopted for break periods exceeding 15 minutes.
On a smooth surface brix tilo 916 gives coverage of 2.5 sft per kg approximately.
brix tilo 916 is supplied in 5kgs, 20 kgs and 50 kgs sacks
12 months if stored in manufacturer’s sealed packs in a cool and dry place away from moisture and heat.
brix products are manufactured under strict quality control measures as per manufacturing specifications.
If the behavior of the product is varying from the claims in the data sheets stop the use of the product and
contact the nearest brix representative.